-
Notifications
You must be signed in to change notification settings - Fork 13.3k
rst cause:4,boot mode(1,6) #2829
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Comments
@sarwadenj no sketch, no basic info, no IDE settings. |
I just started getting exactly the same thing after flashing:
It happens with any sketch, including
I'm using the Arduino IDE 1.8.5, and If I reset by shorting
This seemed like #2414, but I am powering from the same place as when it was working (a USB port). The whole thing started after uploading a sketch that was setting pin 13 as output. Could that be the reason? Any thoughts are welcome. |
Hey everyone.. Exception (9): ctx: cont stack>>> ets Jan 8 2013,rst cause:2, boot mode:(1,6) ets Jan 8 2013,rst cause:4, boot mode:(1,6) wdt reset Please help ASAP..!!! Thanks. |
For some reason, after a few weeks of not touching the board, I no longer have the problem. |
I got same error when my code looped in while(1);. Seem that the board was reset by watchdog. |
I'm having the same issue with my NodeMCU... 09:48:45.503 -> Sdk version: 3.0.0-dev(c0f7b44)
|
cause:4, boot mode:(1,6) I got this when used DS18B20 sensor with U8g2lib.h display. :( |
Have no solution? ets_main.c " Nothing more. I have clicked "Erase" button on ESP8266 Download Tool V.3.6.8, and the prompt shows this message: CONNECT BAUD: 115200.Uploading stub...
|
To everyone having the same Problem as the OP. I had it too. The Problem is, that the ESP8266 crashes during the rotation of the stepper motor because it can not handle the WiFi tasks that continuisly run in the background while only having a few microseconds delay. I added the yield(); function to my rotation loops and the crashes are gone. At least that was the Problem with me, since we are basically doing the same thing and i had the problem i assume this would be the solution for this case too. |
@Archy404 very well!!! |
problem coming after uploading program....
rst cause:4,boot mode(1,6)
GPIO's status after uploading code
CH_PD--VCC
GPIO 15--GND
GPIO 0-Connected to DC MOTOR via N-MOSFET
GPIO 2-Connected to interrupt pin for sensor.....
once MOTOR start rotating after 10sec it throws wdt reset......
previously it is not giving problem with this setup at normal load
The text was updated successfully, but these errors were encountered: